Wednesday, February 15, 2012

Need a wiring diagram for a Ford e250 Econoline van for a remote start?

Just need a little help finding the wiring diagram for my 2010 Ford e250 Econoline van. I am going to install a remote start with alarm.Need a wiring diagram for a Ford e250 Econoline van for a remote start?ECONOLINE 2004 -2008

KEY T-HARNESS IMMOBILIZER

N/A FD-2 (2004-2005 ONLY) N/A

PART COLOR LOCATION DIAGRAM

12 VOLT CONSTANT (3) LIGHT GREEN/PURPLE (+) IGNITION SWITCH HARNESS

STARTER WHITE/PINK (+) IGNITION SWITCH HARNESS

STARTER 2 N/A

IGNITION 1 PINK/LIGHT GREEN (+) IGNITION SWITCH HARNESS

IGNITION 2 BLACK/LIGHT GREEN (+) IGNITION SWITCH HARNESS

IGNITION 3

ACCESSORY/HEATER BLOWER 1 GRAY/YELLOW (+) IGNITION SWITCH HARNESS

ACCESSORY/HEATER BLOWER 2 RED (+) IGNITION SWITCH HARNESS

KEYSENSE N/A

PARKING LIGHTS ( - ) N/A

PARKING LIGHTS ( + ) BROWN (+) @ HEADLIGHT SWITCH

POWER LOCK RED (TYPE C) See NOTE *1 IN EITHER KICK PANEL

POWER UNLOCK BROWN (TYPE C) See NOTE *1 IN EITHER KICK PANEL

LOCK MOTOR WIRE N/A

DOOR TRIGGER See NOTE *2 @ EITHER DOOR PIN SWITCH 14301_ECONOLINE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf

DOMELIGHT SUPERVISION BLACK/LIGHT BLUE (+), Requires Part #775 Relay @ RELAY, to the RIGHT of the STEERING COLUMN

TRUNK RELEASE N/A

SLIDING POWER DOOR N/A

HORN DARK BLUE (-) @ STEERING COLUMN HARNESS

TACH WHITE/PINK @ PCM, Pin 48, See NOTE *3

WAIT TO START LIGHT N/A

BRAKE DARK GREEN (+) @ SWITCH ABOVE BRAKE PEDAL

FACTORY ALARM DISARM N/A

ANTI-THEFT N/A

NOTES

NOTE *1 If vehicle has a FACTORY KEYLESS ENTRY, PINK/YELLOW is LOCK, and PINK/LIGHT GREEN is UNLOCK, it is a TYPE B Door Locking System, if vehicle is without a FACTORY KEYLESS ENTRY, it is a TYPE C System and you MUST TEST from the PASSENGERS LOCK/UNLOCK SWITCH this switch is the MASTER SWITCH..





NOTE *2 This vehicle has a door pin trigger for each door, the DRIVERS DOOR is a RED/PINK (-) the PASSENGER DOOR is a BLACK/WHITE (-) and the SLIDING DOOR if equipped, is a WHITE (-) use all 3 DOOR TRIGGER wires and DIODE ISOLATE when connecting to an ALARM SYSTEM. To connect, See DIAGRAM





NOTE *3 The PCM (Powertrain Control Module) is located under the hood, next to the Brake Master Cylinder. On Diesels the TACH wire is in Pin 1, top of plug, WHITE/PINK wire.

LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2



EXTRA INFORMATION
  • pocket bikes
  • argus
  • No comments:

    Post a Comment